A step-by-step guide on how to fix a leaky shower head

There are three simple remedies you should know about in order to repair a leaky shower head (or a shower head that is loose/dripping):

Filing the shower head/cleaning it

Removing the washer and O-ring

The cartridge valve can be replaced.

In the event that your shower head is always running, it might be a big inconvenience.

Learning how to fix a leaky shower head is important, whether it’s an irritating leaking sound or the anxiety of how much water you consume.

Here’s a great guide on how to fix a leaky shower head.
If you’re researching how to fix a leaky shower head (or a dripping/loose shower head) there are three common repairs you should be aware of:

To thoroughly clean and instal a shower head

Washer/O-ring replacement

replace the cartridge’s cartridge valve

Shower head cleaning/replacement
The main problem is most likely to be in the shower head area, if you receive some water in the shower and only a drip at the bottom.

Whether you can fix the shower head or need to buy a new one depends on your skill level.

If you can, take off the faceplate of the shower head so that you may reach its innards.

To unclog drains, soak the shower head or immerse in a glass of white vinegar for eight hours. These should get rid of any clogs in the drain.

After eight hours, take the shower head off, clean it well, and then use your fingers to remove any debris that may have accumulated. A rag and a toothpick are the only tools required for this task.

Remove the shower head, and then reconnect it. Although you’ve hopefully addressed the leak, in the event it hasn’t been corrected, you’ll need to replace the shower head or attempt an other solution.

Washer/O-ring replacement
It is often the case that the rubber washer has to be changed (or O ring). One of them is often located beneath the levers or taps you use to switch on the shower, while the other is often found inside the shower head. You only get one washer if you have a single lever.

To replace these, first turn off the water supply. The shower head is the simplest to access so start there. Unscrew it from the shower and, in most cases, you’ll find it behind a nut. This is simple: just remove the washer and instal the replacement. You should get the appropriate size.

Recheck the shower head’s placement and then test the repair to determine whether the leak has been fixed. Fixing the problem means you have identified the issue; if not, you will have to consider different washers.

Next, use a pair of pliers to remove the taps or lever. Screwing them out of the camera can be done in most circumstances. When the trim and sleeve that covers the stem is removed, you will have to remove all nuts and washers until you reach the washer.

Use a new washer, the same size, and lift it off. Check to determine if the problem has been addressed by turning the water back on and replacing the tap or lever.

replace the cartridge’s cartridge valve
The next stages may have to be more technical if the first one fails.

In order to shut off the water supply, you’ll have to unscrew the tap head and handle.

Each of the taps have their own individual cartridges, however all of them can wear out with use. Usually of a golden colour, though you can see a silver one instead.

Removal is simple if your cartridge has a nut that can be loosened and the valve removed with pliers. Some specialised tools may be required.

You will need to replace it after it has been released to the public. After you’ve finished the task, return the tap to its original position, turn the water back on, and test the shower.

If your looking for reliable bathroom fitters in Glasgow click here